HAPRO Luxura V10, Manual

Page: 16 / 160

16
ERROR
“Not present”
If an option is not available on the appliance, the message “NOT PRESENT” will
scroll across the bottom of the display. This means that the function in question
is not available to use.
Cooling down (appliance / face tanner)
When the appliance or the face tanner is switched off , a mandatory cooling off
period will start automatically.
An hourglass will appear at the top of the display and a number will appear at the
bottom (indicating the remaining cooling off time in seconds).
Doors open
Opening the doors during tanning will activate the pause mode:
• The lamps will switch off automatically.
• The body cooling will remain on (4 minutes).
• Xsens and Qsens will be paused.
• The lift will lower automatically.
The message “PLEASE CLOSE DOORS” will scroll across the display.
If an error occurs, “ERROR” will scroll across the top of the display, and a code will
appear at the bottom.
E1 = Overrule error
E2 = Communication breakdown with the switch mechanism
E3 = Relay error
Attention:
If one of the error messages appears on the display, you should stop using the sunbed, unplug the
appliance and contact your dealer.
Messages
GENERAL
Press the following keys successively:
<STOP> <STOP> <PLUS> <STOP> <MIN>
The appliance comes set up for use with an external timer or coin-op. To change
this, the following procedure applies.
The main parameter “P1” will appear at the top of the display, and the name of the
main parameter “UNIT” will scroll across the bottom.
Press <START> 1x.
Choose a number between “1” and “30” for stand alone use.
Choose “0” to use the sunbed with a coin-op.
Press <START> to save the chosen number.
The parameter “1” will appear at the top of the display, and the name of the
parameter “START TIME” will scroll across the bottom.
Press <START> 1x.
The number “1” appears at the top of the display and the current parameter
number appears at the bottom. This number is the maximum tanning time (in
minutes) per session.
Use the <MIN> and <PLUS> keys to adjust the number accordingly.
Choose coin-op or stand alone