EN
(46)
Haojue HJ125-8 99011H30220H000 V02 EN+FR 2015-3-2
B
WARNING
After a new brake disc or pad is installed, the
braking distance may be a little longer than the
original value.
After the brake discs and brake
pads have realized full break-in following a mileage
of about 300 km, the best braking effect will be
realized.
Make sure there is an enough braking
distance when riding before that.
B
WARNING
Fail to inspect and maintain the brakes pads or
brake disk, and replace them when recommended
can increase your chance of having an accident.
If you need to replace brake disk or brake pads,
have your Haojue dealer do these works. Inspect
and maintain the brake disk and brake pads as
recommended.
REAR BRAKE (DRUM BRAKE)
Adjustment of rear brake pedal
Free stroke
1
of the rear brake pedal refers to the stroke
between the pedal’s free position and the pedal’s position
when the pedal is stepped down on to brake the rear
wheel.
When adjusting the free stroke
1
of the rear brake pedal,
set the pedal at a comfortable position, adjust the pedal
by rotating the pedal limiting bolt
2
and then rotate the
adjusting nut
3
. Turn it clockwise for a smaller free stroke,
or anticlockwise for a larger one. Make the free stroke
1
20–30mm.
NOTE: If follow the steps, the free stoke is not required,
please have it checked by the authorized dealer.
The mark
extending line is in
the allowed range
Wear limit of rear brake
There is a wear limit mark on
the rear brake of the motorcycle.
Inspect the wear situation of the
rear brake following the essentials
below.
1. Inspect
whether the
braking
system
has
been
properly
adjusted.
2. Operate the braking system and
inspect and make sure the mark extending line
1
is
in the allowed range
3
(see the figure) marked on the
wear limit mark
2
, otherwise have the component in
the rear brake replaced by a qualified distribution and
maintenance organization for safety.
(46)
Haojue HJ125-8 99011H30220H000 V02 EN+FR 2015-3-2
44
