Haojue HJ110-5 99011H53150H000 V01 EN 2016-5-27
(37)
CLUTCH
Adjust the clutch by the following
steps:
1. Unscrew the clutch locking nut
1
.
2. First, clockwisely revolve the
clutch adjusting screw
2
for one
loop, and pay attention not to
revolve too much.
3. Then, anticlockwisely revolve the clutch adjusting
screw
2
until feeling a slight resistance.
4. From this position revolve the clutch adjusting screw
2
for a 1/18–1/12 loop (20–30 degrees), and then
screw up the locking nut
1
.
5. After the adjustments, start up the engine while
checking whether any skids occur in the clutch and
the gear positions can be smoothly alternated.
B
WARNING
If the clutch cannot be properly adjusted or the
clutch does not work properly, contact the dealer.
CARBURETOR
Stable carbureting evaporation is the most fundamental
requirement for the carburetor.
The carbureting
evaporation has been accurately set in the factory. Please
do not change its setup. You only need to pay attention to
two things: idle and throttle cable free-play.
Adjustment of idle speed
1. Start the engine, keep it running
at idle till fully pre-heated.
2. After the engine has been pre-
heated, release the throttle, turn
the adjusting screw to right and
left to keep the engine revolving speed between 1400–
1600 rpm.
B
CAUTION
Adjustment the engine idle speed should be done
when the engine has been fully pre-heated.
0.5–1.0mm
THROTTLE CABLE PLAY
1. Remove
the
rubber
bush(s)
along the throttle cable.
2. Loosen lock nut
1
.
3. Turn the adjuster
2
so that
the throttle cable has 0.5–1.0mm
play.
4. Tighten the lock nut
1
.
5. Reinstall the rubber bush(s).
36
Haojue HJ110-5 99011H53150H000 V01 EN 2016-5-27
(37)
