10_
installation & connection
installation & connection
INSTALLATION
J
`
This camera is waterproof and in compliance with the IP66 spec, but the jack connected to the external cable is not. You are
recommended to install this product below the edge of eaves to prevent the cable from being externally exposed.
Precautions before installation
Ensure you read out the following instructions before installing the camera:
~
Select an installation site that can hold at least 5 times the camera’s weight.
~
Stuck-in or peeled-off cables can cause damage to the product or a fire.
~
For safety purposes, keep anyone else away from the installation site.
And put aside personal belongings from the site, just in case.
~
If the product is installed with excessive force, it may cause damage to the camera due to malfunction.
Forcing assembly using non-compliant tools may damage the product.
Inserting a Micro SD card
1.
Unfasten two screws on the Micro SD card cover by turning them counterclockwise using the Torx
screwdriver.
TR20
J
`
Disconnect the power cable from the camera before inserting the Micro SD card.
`
When it rains or the humidity is high, insertion or ejection of a Micro SD card is not recommended.
`
When installing/removing the Micro SD card, make sure you put the product body on a flat ground before working on it in order
to prevent accidents due to loss or drop of any parts.
`
Do not remove the screws.
2.
Pull up the Micro SD card cover and push the Micro SD card to the arrow direction as shown in the figure.
J
`
Do not forcefully insert it in the reverse direction. It might damage your Micro SD card and your product.
3.
Assemble the camera in the reverse order of disassembly after the Micro SD card is inserted.
J
`
Tighten the screws when assembling the Micro SD card cover to prevent moisture penetration.