- 15 -
D. Precaution of Equipment Operation
1) Only certified operator must operate the equipment.
2) While working on board platform, seat belt and belt strap must properly wear.
3) When heavy item is loaded on the boom and boarding platform, be careful not
to exceed. (2 persons or 300 Kg) Do not load that exceeds the limit.
Excessive weight may cause deterioration of the equipment function or safety accident.
Please comply with the standards.
4) If the boom remote control have electrical jamming or any disconnection, switch
on the emergency power of the transmitter. You must take this action the
problem will no longer occurs.
5) Stop and prohibit the operation if you experience bad weather conditions. Below
were as follows.
- During heavy rain
- During heavy snow.
- During thunder and lightning storm
- By ambient conditions such as fog, when the visually impaired
- When the wind speed exceeds 10m/sec
6) Check the passenger's safety prior operation of the equipment.
7) Avoid passing on the boom, and do not come in and out on the boarding
platform.
8) When operator comes in the boarding platform, the boom should reach the
bottom of the ground so that the boarding platform will also reach the ground
floor, through that, the operator must be able to go on boarding.
9) When you ride down on a boarding platform into the ground, you must be
specially careful on the lever operation
10) The equipment operator access all the action as possible
11) Do not change the boom speed randomly.
12) Do not exceeds the limits of the operation.
13) Operator should maintain stable condition to operate the operation. Do not use
ladder, planks or other tools to reach the location.
14) Movement of vehicle or outrigger manipulation where there are people on the
board should absolutely prohibited as the boom spread.
15) Prohibit the booms or boarding platform by pushing or pulling objects.
16) Workers inside the boarding platform including stuff aboard must be careful
from falling down.
17) Be careful from moving the boom around the person or obstacles.
Summary of Contents for HS Series
