Hansin Special Equipment HS Series, Instruction Manual & Repairing Manual

Page: 14 / 32

- 13 -
Safety Rules
This Equipment will have a good performance, if you do it right.
During the equipment operation, in order to prevent safety accident, be sure to
follow the basic rules and regulation.
So, the operator takes all the responsibilities to follow the basic safety regulation
for people and equipment.
The operator should have no doubt in concerned to warning device and safety
device of equipment.
Not following the safety regulation may resulted to safety accident.
You either required to master the operation sense too.
The operator need to follow the safety regulation as well as duty to forestall the
safety accident while doing the equipment operation.
A. Precaution before Operation
1) Always park in a flat and solid or paved road place where you can pull the
parking break.
2) Without interfering obstructions in the working area go to a near place where
you can find easy access.
3) Without moving the vehicle, it is possible to perform many task at any route.
4) Put a wedge under the wheels of the vehicle to prevent accidents while
working in a sloppy areas.
B. Precaution of Outrigger Operation
1) Properly install the outrigger on the floor.
2) To ensure stability, spread the outrigger beams as much as possible.
3) The installation should be firmed to get in touch with the outrigger cylinder
support.
4) Within the inclined position of the truck, put down the lower end outrigger
following the higher outrigger to ensure vehicle horizontality.
5) If the area to be used anywhere is uneven or soft ground you should have
competent support.
6) Due to slippy situation while the vehicle shaking, put the wedges carefuly to
prevent from falling down.
7) When operating in a soft ground, put down the outrigger and place a wedges.
then check the condition of ground.