Assembly
Page EN-13
Before getting started
• Read chapter “Safety” on page EN-4 and
all the safety notices.
Place the drill holes
WARNING
Risk of injury!
Improper installation of the appliance
can lead to injury.
■
Before drilling the holes, ensure that
no wires or cables (power, gas, water
etc.) will be damaged (check with a
line locator).
CAUTION
Fire hazard!
■
The distance between the cooking
surfaces and the lower edge of the
exhaust hood must be at least 65 cm
for gas stoves.
■
For gas stovetops, you must read the
user manual for the stovetop! If the
manual stipulates a larger distance,
this must be observed.
1. In order to place the appliance exactly
over the centre of the stovetop, first use
the pencil to draw a vertical guiding line
on the wall. Ideally, use a level or a plumb
bob from the ceiling of the room to the
middle of the stovetop.
2. Draw the six drill holes on the wall, follow-
ing the diagram on page 12. Make sure
the distances between the holes are cor-
rect.
3. Drill holes at the marked points, using a di-
ameter that can accommodate the dowels.
4. Place the dowels into the holes.
Attaching the exhaust hood
(5)
(5)
Pins
1. Place the two halves of the check valve
(5) into the opening on the top of the ex-
haust hood (1). Make sure that the pins
on the valve are facing outwards.
2. Screw the two round-head screws (11)
for hanging the exhaust hood into the
dowels. There must be enough space
between the wall and the heads of the
screws so that the exhaust hood can be
hung by the keyhole openings.
(13)
(14)
(15)
3. Flip the cover (13) up.
4. Open the locks (14) on the grease fil-
ters (15) and carefully pull the grease fil-
ters (15) downwards to remove them.
