Page EN-21
Installation
– If the hob is installed over an oven with
ventilation, the clearance between the
base of the appliance and the cover of the
oven must be at least 100 mm.
– At the front of the hob, there must be an air
outlet at least 10 mm in size between the
hob and the oven or floor unit.
– Veneers, plastic coverings and adhesives
used must be heat-resistant up to 100 °C.
Air outlet
Air outlet
– The hob must be positioned in such a way
that the air outlet is not compromised.
490 mm
560 mm
520 mm
590 mm
>50 mm
>50 mm
>50 mm
>50 mm
• Cut a recess in the worktop:
490 × 560 mm (D × B).
If a hob was already installed, the recess
cut for it must have the same dimensions.
Installing the hob
1. Remove the hob from the packaging.
2. Remove all protective and packaging ma-
terials.
3. Turn the hob over and place it upside
down on a soft, clean surface, for exam-
ple the packaging. Otherwise the hob
could be scratched.
(15)
(16)
(15)
4. Insert the short, angled end of the two
enclosed retaining clips (15) into the slots
provided on the underside of the hob.
5. Screw down the retaining clips using the
enclosed screws (16)
6. Place the hob, with the sensor field facing
forward, into the worktop recess. Align it
evenly and press it firmly into place.
Hob
Worktop
(15)
The hob is fastened using the two retaining
clips (15).
7. Clean the hob thoroughly before its
first use see “Cleaning the hob“ on
page EN-18).
