Seite EN-38
Start-up
Establish drain for water
WARNING!
Risk of scalding!
■
Fix the hose to the sink or bath to pre-
vent it from slipping due to the recoil
caused by pumping.
■
For drains, make sure that the cross
section of the discharge pipe is great
enough that the sink cannot overfl ow.
NOTICE
Risk of damage to property!
■
Use only the water outlet hose pro-
vided.
■
Do not extend the water outlet hose
or replace it with another hose.
■
The water drainage hose must not
get bent or twisted.
■
The curvature of the water outlet
hose must be at least 60 cm (max.
100 cm) above the ground to ensure
the water drain functions perfectly.
■
The water outlet hose must be in
the retaining clips on the back of the
appliance so that the curvature al-
ways remains above the waterline
inside the appliance. The end of the
hose must not be submerged in the
pumped water.
You can fit the outlet hose in two ways:
Self-assembly: Fixing with a hose
holder
• Put the end of the hose (17) over a hose
holder and hang it over the edge of a
bath. (You can find a hose holder in a
specialist shop or DIY store.)
Installation by a specialist:
Attaching the discharge manifold
to a washbasin
• The outlet hose (17) is mounted onto a
special device, which can be found on
the outlet manifold of a washbasin. In
doing so the lock on the siphon must be
removed.
Have this fixed by a specialist!
There is a washer in an unused con-
nection manifold to ensure that no
water can run out. This washer must be
replaced by a seal ring before connecting
the outlet hose.
