Start-up
Page EN-12
Before starting to use the
appliance
• Read chapter „Safety“ from pagepage EN-4
and all the safety notices.
Unpacking and setup
WARNING
Risk of suffocation!
Children can become entangled in the
packaging fi lm or swallow small parts
and suffocate.
■
Do not allow children to play with the
packaging fi lm.
■
Prevent children from taking small
parts out of the accessory bag and
putting them in their mouths.
CAUTION
Risk of injury!
Improper handling of the appliance
may result in injury.
■
The appliance is heavy and bulky. Ask
another person to help with moving
and installation.
■
Do not pull or lift the appliance by its
doors or door handles.
■
Base, drawers, appliance doors, etc.
must not be used as steps or for sup-
port purposes.
Dangers from the refrigerant!
Improper use of the appliance may
lead to injury or damage to health.
■
Do not damage the refrigerant cir-
cuit, e.g. by puncturing the refrigerant
channels of the condensate evapora-
tor with sharp objects, bending the
piping, or cutting open the insulation.
■
Refrigerant is fl ammable when spurt-
ing out and can damage the eyes. If
this happens, rinse eyes with clean
water and call a doctor immediately.
NOTICE
Risk of damage to property!
Improper handling of the appliance
may result in damage.
■
If possible, do not tilt the cooling ap-
pliance horizontally.
■
Do not use sharp or pointed objects
to unpack it.
■
When unpacking the appliance, nev-
er damage the insulation material on
the back of the appliance.
The appliance may not operate proper-
ly if exposed to low ambient tempera-
tures for extended periods of time. This
can then lead to an increase in temper-
ature inside the appliance.
■
Always ensure the prescribed ambi-
ent temperature is maintained (see
„Intended use“ on page EN-4).
1. Unpack the appliance and remove all pack-
aging, plastic moulding, adhesive strips,
protective film and foam padding from the
inside, outside and back of the appliance.
2. Place the appliance on as flat and as firm
a base as possible. Observe the specified
minimum distances
.
– Suitable locations are dry, well-ventilat-
ed areas that are as cool as possible.
– Unsuitable locations are ones with direct
sunlight or which are directly next to an
oven, hob or radiator.
3. If underfloor heating is installed at the set-
up location, place the cooling appliance on
an insulation plate made from solid mate-
rial. Make sure that the ambient tempera-
tures match the climate category of the ap-
pliance (see „Intended use“ on page EN-4).
Start-up
