Page EN-22
Care and maintenance
2. Turn the coarse filter anticlockwise and
remove the filters (20) upwards.
3. Clean the filters carefully under running
water.
4. Replace the filters and turn the coarse fil-
ter clockwise up to the stop.
Cleaning the wash arms
The nozzles in the spraying arm may calcify
or become dirty due to food scraps. Check
the nozzles regularly and clean them if re-
quired.
1. Empty both racks (16), (18) and remove
them.
2. Pull the lower wash arm (24) up and out.
3. The upper wash arm is attached by
means of a bayonet fitting. To remove,
hold the bayonet fitting firmly and release
the wash arm by turning it clockwise.
4. Clean the nozzles under running water.
5. Affix the spraying arm again after clean-
ing.
The spraying arm must be firmly affixed and
must be able to rotate freely.
Complete cleaning
In well-stocked supermarkets and drugstores,
you will find special dishwasher cleaning
products. Cleaning the appliance using these
products takes place when the dishwasher is
empty and is very intensive. You should clean
the dishwasher in this way from time to time.
When doing so, please note the manufactur-
er instructions on the packaging.
Protection against frost
damage
Position the dishwasher in an area which is
protected from frost, if possible. If this is not
possible, protect the dishwasher against frost
as follows. You will need a shallow dish or
pan and a sponge.
1. Pull the mains plug out of the socket.
2. Turn the tap off and unscrew the inlet
hose (27).
3. Let the water from the inlet hose flow
completely into the dish.
4. Remove the filters (20).
5. Remove the water from the sump floor
with the help of a sponge.
