Page EN-31
Troubleshooting table
Problem
Possible cause
Solution
The display
(13) is illuminated
although dishwash-
er salt has been
added.
The dishwasher salt is
clumpy.
Stir the dishwasher salt using the end of a
spoon or similar.
The water is not
running or it is
running only very
slowly.
There is a kink in the inlet
hose.
Lay out the inlet hose in such a manner
that it is not kinked.
The water tap is not proper-
ly on.
Turn the water tap on completely.
The water is not
running off or only
very slowly.
The filters are blocked.
Clean the filters (see page EN-21).
The outlet hose is kinked,
has been extended or is
hanging too high up/too low.
Lay out the outlet hose in the proper man-
ner (see page EN-23).
The dishwasher is
not watertight.
The door seal is defective. Have the door seals replaced (see „Ser-
vice“ on page EN-33).
The outlet hose or the inlet
hose is defective.
Have the defective hose replaced (see
„Service“ on page EN-33).
The dishwasher
can be switched
on/off, but not can-
not be operated.
The dishwasher can only be
operated when the door is
closed.
Close the door.
Error messages on the display
Code
Solution
E1
: It takes too long
for the water to fill
up.
Turn the water tap on completely.
Lay out the inlet hose in such a manner that it is not kinked. See „Connect-
ing the inlet hose“.
Ensure that the water pressure is correct. See „Setting the water hardness“
on page EN-28.
E4
: Water overflow Switch off the tap. Find the gap in the seal (or have someone find it) and
repair the leak (or have it repaired).
