Hans Grohe iControl mobile 15942000, Instructions For Use/Assembly Instructions

Page: 25 / 313

24
English
Fittings
The external transformer provides 50 VA. The trans-
former must be installed in the dry area (protected
zone 3). The transformer can be installed together
with the receiver in a plastic housing, while ob-
serving EN/IEC 60335-1. (dimensions approx.
250 x 160 x 92 mm, not included in the delivery.)
The included cable allows the installation of the
transformer, up to 7 m away from the receiver. For
this, you must provide an empty pipe EN35 (not
included in the delivery). This empty pipe must be
affixed at least every 500 mm and the bending
radius must be greater than 100 mm.
The secondary line of the transformer, which is
approx 7 m long, must not be shortened. The un-
used line length should be stored near the safety
transformer. A damaged connecting line must not
be replaced. The transformer may no longer be
used.
A damaged connecting line must not be replaced.
In case of a defective mains cable, the entire cable
including the transformer must be replaced by a
trained electrician.
Transformer:
Light relay: (for models with integrated lights only)
The max. load for the light relay is 12 V AC /
80 W.
Do not use with 230 V power.
Assembly see page 303
Light control:
27189000
(order as an extra)
(iControl mobile 15944000
On the models with external light source, the light
control must be connected. The light control must
be accessible at any time.
Connecting line Solenoid valve block /
Connecting line Light:
The solenoid valve block line (7.50 m) and the light
cable (10.00 m) may not be shortened. The excess
cable length should be stored near the receiver.
The solenoid valve block line and the light cable
may only be routed in the enclosed empty pipe
(EN 20).
This empty pipe must be affixed at least every 500
mm and the bending radius must be greater than
100 mm.
Important: No electrical lines carrying a voltage
of more than 12 V may be routed in the empty
pipes for the solenoid valve block line and the
light cable.
Coding plug: (Raindance Rainfall 28411000 /
Raindance Rainmaker 28403000)
The coding plug must be connected on the models
without light.
If the service mode is activated on models without
light, the LED of the coding plug will display the
visual return messages.
The coding plug must remain accessible.