2 5
TO PRINT STORED DATA
Once a log number is selected (see
"TO SCAN STORED DATA ON DISPLAY"
on page 23) you can print all or part
of that logged section by pressing the
ALT and PRT keys. The printer will
start to print the logged section begin-
ning with the selected sample number
without altering the content of the
memory.
Note:
It is always possible to print
only the sample shown on the
display by pressing the PRT key.
Note:
Before proceeding with printing, make sure there is enough
paper for the data to be printed. When the paper is finished
the meter will not advise the operator and the printouts could
be lost. If this happens, stop
the printer by pressing ALT and
PAPER simultaneously.
Insert a new paper roll and repeat the instructions above
starting from the last printed sample number (see chapter
"PRINTER MAINTENANCE" on page 32 for changing the paper
roll).
ALT
+
ALT
PRT
+
PRT
ALT
PAPER
+
WORKING EXAMPLE (HI 9181 & HI 9184 ONLY)
The following is a step by step procedure of a typical monitoring
situation where we have assumed that the batteries have been in-
serted and the date and time correctly set.
In this example, the meter stores the temperature every 2 minutes. It
will log 10 samples but print only 3, then displays the data contained
in sample number 1 and prints samples 5 through 10.
Example:
Step One - Setting the printing/logging interval at 2 minutes:
Press ALT and TIME. The display will now ask for the password (unless
it was left at 0000).
ALT
TIME
+
CH
°C
