![background image](http://html.mh-extra.com/html/hanna-instruments/edge/edge_instruction-manual_591686015.webp)
Setup/Installation
15
The following General Setup parameters are displayed with all probe
measurements and remain if switching to another probe type. Only these
parameters are available when no probe is attached. Parameters are tabulated
in the table below with choices and default values. Parameters are accessed
by pressing SETUP. Loop through the parameters by using the
p q
arrows.
To modify a setting, press MODIFY. The parameter may be modified by using
u
,
p
and
q
arrows. Press CFM to confirm the change. To exit SETUP press
SETUP.
Parameter
Description
Choices
Default
Basic mode*
(EC and pH)
*Only seen
when cable
connection
between micro
USB and PC is
made.
Select to log
data on edge™
or to export data
to PC
Log on edge™ of
export to PC
Log on edge™
Available
Log
Select log type
to be used
from 3 types of
logs: Manual,
Manually
initiated
Stability log
(3 settings
available), or a
continuous Lot
logging with
measurements
logged in timed
intervals.
Manual Log
Stability Log:
Fast, Medium,
Accurate;
Interval Log:
Seconds: 5, 10,
30; Interval Log
Minutes: 1, 2, 5,
15, 30, 60, 120,
180.
Interval
(5 Sec)
Manual log
or
Stability log:
Medium
Set Calibration
Expiration
Warning
Meter will
indicate “CAL
DUE” when
set time in this
parameter has
been exceeded.
1, 2, 3, 4, 5, 6, 7
days or OFF
Not available
General
Setup
Summary of Contents for Edge
