34
35% Extra 300 ARF Assembly Manual
3. Apply Shoo Goo to the underside of the shoulders and
the rear rail of the canopy.
4. Mount the pilot. Apply some pressure and let the
canopy sit on a flat surface until Shoo Goo cures.
5. The model comes with instrument panels. Cut the
instrument panel decals to size and install on the front and
rear dash boards in the cockpit.
The picture below shows the front pilot panel.
Receiver, Switch and Throttle Servo
Regulator Installation
Required Parts
Fuselage
Required Parts (not included)
JR 5203 regulator
AR9110 Receiver
Required Tools and Adhesives
Masking tape
Medium CA
CA accelerator
Du-Bro 1/4-inch foam
Hook and loop
JR servo extension, 3-inch
1. Prepare the receiver to mount on the tray, similar to
the ignition battery preparation in the previous section. Put
two pieces of masking tape at the bottom of the receiver.
Using CA glue 1/4-inch Du-Bro foam to the masking tape
and glue a piece of hook and loop to the foam.
