MODEL MFT
MODEL MFT
MODEL MFT
MODEL MFT
MODEL MFT
FLANGE FACING CONVERSION
Confirm the date of manufacturing for your
model MFT. Tools built before March of 2003 will
require that holes be drilled and tapped in the
housing to accept the trip ring. Typically, these
tools are returned to the factory for this process.
Should you elect to perform this operation,
contact the factory for exact location and sizes.
Once you have confirmed that your tool has the
appropriate mounting holes, proceed with the
following instructions.
Step 1:
Remove the feed nut
handles (A) by unscrewing
them from the feed nut.
Step 2:
Remove the cap
screws (B) that lock the
retainer ring onto the feed
nut. Remove both halves of
the Retainer Ring and slide
the feed nut off of the tool.
Step 3:
Remove the Tool
Holder by loosening the
three set screws (C).
Step 4:
Install the feed
nut handles (A) into the
Flange Facer feed nut.
Step 5:
Install the
Flange Facer Feed Nut
(D) and replace the
Retainer Rings.
Step 6:
Secure the Trip Ring (E) to the housing
with the cap screws provided.
B
Step 7:
Mount the Flange Facer Head
Assembly (F) onto the Drive Hub (G) with the
two (2) keys from the tool holder and two (2) set
screws provided.
With the conversion complete, refer to setup
and operating instructions for tool and cutter
positioning instructions.
A
C
D
A
E
F
G
