AI-006 operation manual
release 12.10.29 R01, HMI version 25, plc version 107>, servo version 102>
P.33 of 44
>
Advance Operation (cont.)
>> Electronic Nozzle Position Adjustment (cont.)
The normal nozzle adjustment is full speed mode, this is the nozzle position when the roller is
running at preset sealing speed. Press 1 into 1 to enter this mode. Then start sealing using
some test fabric and tape. Adjust the x-direction and the z-direction by pressing on the
corresponding buttons while the nozzle is engaged. Adjust the distance between the nozzle and
roller by the y-direction buttons so as to generate the best sealing result. You may need to have
the test fabric go thru some predefined testing procedures (like hydrostatic test, wash test, etc.)
before confirming the correct settings.
For AI-006 to work properly in the variable speed sealing mode, the nozzle position setting at the
half speed mode is required. Once this procedure is finished, the nozzle will be repositioned
automatically according to the sealing speed in the variable speed sealing mode.
Press 1/2 into 1/2 to enter into half speed nozzle adjusting mode. Adjust the position of the
nozzle the same way as in the full speed nozzle adjusting mode. At this time, please note that
the roller is running at half of the preset sealing speed.
When finished nozzle adjustment, exit from the page ‘nozzle adjust’ to resume normal
operation.
WARNING !
The nozzle position is allowed to be adjusted in any position in the 3-dimensional
space, within the range. When adjusting nozzle very close to the roller, be careful to
avoid the nozzle from hitting the roller. This can be done by adjusting a little bit at a
time while keeping eyes on the gap. Failure to do so may cause damage to the nozzle
positioning system.