81
NAUTIZ X7 Manual - Chapter 9
RF Exposure Information (SAR) for Non-WWAN Version
This device meets the government’s requirements for exposure to radio waves.
This device is designed and manufactured not to exceed the emission limits for exposure to radio frequency (RF) energy set by
the Federal Communications Commission of the U.S. Government.
The exposure standard for wireless devices employs a unit of measurement known as the Specifi c Absorption Rate, or SAR. The
SAR limit set by the FCC is 1.6W/kg. *Tests for SAR are conducted using standard operating positions accepted by the FCC with
the device transmitting at its highest certifi ed power level in all tested frequency bands. Although the SAR is determined at the
highest certifi ed power level, the actual SAR level of the device while operating can be well below the maximum value. This is
because the device is designed to operate at multiple power levels so as to use only the poser required to reach the network. In
general, the closer you are to a wireless base station antenna, the lower the power output.
The highest SAR value for the device as reported to the FCC when tested for use at the ear is 0.134 W/kg and when worn on the
body, as described in this user guide, is 0.036 W/kg. (Body-worn measurements differ among device models, depending upon
available enhancements and FCC requirements.)
While there may be differences between the SAR levels of various devices and at various positions, they all meet the government
requirement.
The FCC has granted an Equipment Authorization for this device with all reported SAR levels evaluated as in compliance with the
FCC RF exposure guidelines. SAR information on this device is on fi le with the FCC and can be found under the Display Grant
section of http://www.fcc.gov/oet/fccid after searching on FCC ID: QYLPS236.
For body worn operation, this device has been tested and meets the FCC RF exposure guidelines for use with an accessory that
contains no metal and the positions the handset a minimum of 1.5 cm from the body. Use of other enhancements may not
ensure compliance with FCC RF exposure guidelines.
