Hand Held Products IMAGETEAM 3800E, User Manual

Page: 42 / 144

3 - 8 IMAGETEAM™ 3800E User’s Guide
Note: If you make an error while scanning the digits (before scanning Save),
scan Discard on the back cover, scan the Intercharacter Delay bar code,
scan the correct digits, and Save again.
To remove this delay, scan the Intercharacter Delay bar code, then set the
number of steps to 00. Scan the SAVE bar code from the inside back cover.
User Specified Intercharacter Delay
This is a delay of up to 495 milliseconds (in multiples of 5) placed after the
transmission of a particular character of scanned data. You can program up to
99 steps (of 5 ms each) to follow the character you specify. Scan the Delay
Length bar code below, then the number of steps for the delay, and the SAVE
bar code from the inside back cover.
Next, scan the Character to Trigger Delay bar code, then the 2 digit hex value for
the ASCII character that will trigger the delay (refer to the Decimal to Hex to
ASCII conversion chart on
page 3-5 ).
Note: If you make an error while scanning the digits (before scanning Save),
scan Discard on the inside back cover, scan the Character to Trigger
Delay bar code, scan the correct digits, and Save again.
To remove this delay, scan the Delay Length bar code, and set the number of
steps to 00. Scan the SAVE bar code from the inside back cover.
1 2 3 4 5
Intercharacter Delay
Prefix Scanned Data Suffix
Intercharacter Delay
Delay Length
Character to Trigger Delay