EN
51
The high-pressure washer stops The fuse has tripped
Incorrect mains voltage�
Heat sensor activated�
The nozzle is partially blocked�
Replace fuse� Turn off other
machinery�
Check that the mains
voltage corresponds with the
specification on the model
label�
Allow the high-pressure washer
to cool for 5 minutes�
Clean the nozzle�
The fuse trips
Fuse is too weak�
Change to an installation
which can cope with higher
amperes than the machine’s�
Try using the appliance without
an extension cord�
The high-pressure washer
pulsates
Air in the inlet hose�
Insufficient water supply�
The nozzle is partially blocked�
Clogged water filter�
Fold in the hose�
Run the machine with open
trigger until normal working
pressure is built up�
Check that the water supply
corresponds with the
requirements stipulated�
Note� Avoid using long, narrow
hoses (min� 1/2 inch)�
Clean the nozzle�
Clean the filter�
Straighten out the hose�
The high-pressure washer
frequently starts and stops
by itself
Pump/spray gun leaking�
Contact Jula’s service
department�
The high-pressure washer
starts, but no water comes out
Pump/hoses or accessories
are frozen�
No water supply�
Water filter clogged�
Nozzle clogged�
Wait for pump/hoses or
accessories to thaw out�
Connect incoming water�
Clean the filter�
Clean the nozzle�
With problems other than the above-mentioned, contact Jula’s service department�
Summary of Contents for 220-137
Page 53: ......
