EN
43
electrical accidents� Check with a qualified electrician if you are uncertain
whether the socket is earthed correctly� Do NOT alter the high-pressure
washer’s mains plug to fit in a socket, but rather have a qualified
electrician install a correct socket�
• The following should be observed when the high-pressure washer is connected
to the mains:
– The electrical installation must be carried out by a qualified electrician
and comply with IEC-364�
– It is recommended that the power supply for this high-pressure washer
has a residual current device with a tripping current of max� 30 mA in 30
ms�
• Only use uncontaminated water�
• Fit an extra filter if there is a risk of sand entering the incoming water (e�g�
from your own well)�
• Safety devices
– The relief valve can reduce the pressure if it exceeds the preset values�
The spray gun has a locking device� The gun cannot be used when the
lock is activated�
– Heat sensor: A heat sensor protects the motor against overloading� The
high-pressure washer starts again after a few minutes, when the heat
sensor has cooled�
SymBOLS
Warning
Safety information marked with this
symbol must be followed in order to
prevent personal injury�
Eye protection
Always wear safety goggles with side
guards or full face protection when
using the high-pressure washer�
The machine is not suitable for
connection to the drinking water
supply
Summary of Contents for 220-137
Page 53: ......
