Hamron 220-137, User Instructions

Page: 49 / 53

EN
49
START
1� Fully open the water tap�
2� Release the safety lock (Figure 8), and then press the trigger for a few seconds to remove air
and residual pressure in the hose�
3� With the trigger pressed in, put the switch (Figure 9) in the ”ON” position�
4� Always keep the trigger pressed in when the motor is started�
STORAGE
WARNING! Before using the high-pressure washer again, it should be rinsed out with clean water�
Antifreeze can damage painted surfaces, so ensure that there is none left in the system�
1� Turn off the high pressure washer�
2� Turn off the water tap�
3� Any remaining cleaning agent must be removed from the container after use�
4� Release residual pressure by keeping the trigger pressed in until no more water comes out
from the water pipe’s nozzle�
5� Activate the spray gun’s safety lock�
6� Remove the plug from the socket�
7� Run the high-pressure washer with non-corrosive/non-toxic antifreeze before winter storage�
mAINTENANcE
NB The plug must be removed from the power socket before carrying out any maintenance�
• For optimum function, check and clean suction and cleaning agent filters after 50 hour’s use
(Figure 10)�
8
Trigger
9