EN
42
• High-pressure hoses, fittings and couplings are important for the high-pressure
washer’s reliability� Only use hoses, fittings and couplings recommended by the
manufacturer�
• Do not use the high-pressure washer if the power cord or important parts, such
as safety devices, high-pressure hoses or the nozzle, are damaged�
• If an extension cable is used, the plug and outlet must be watertight�
• Faulty extension cables can be dangerous�
• This high-pressure washer must not be used at temperatures below 0°C�
• Cable and reels must always be fully unwound to prevent the cable
overheating�
• Follow the requirements for cable length and dimension below�
– 1�0 mm² max� 12�5 m
– 1�5 mm² max� 20 m
– 2�5 mm² max� 30 m
• Electrical connections must be kept dry and located above ground�
• If the cable is damaged, it must be replaced by the manufacturer or its service
workshop or similar qualified person to avoid hazards�
• Always place the high-pressure washer on a solid and flat surface when it is
used, handled, transported or stored� If the machine falls over there is a risk of
damage to the casing�
• In the event of an accident or breakdown, the high-pressure washer must be
immediately turned off (rinse with a large amount of clean water after contact
with cleaning agent)�
NB
• If the power supply is deficient, short voltage drops can occur when the
high-pressure washer is started� This can affect other equipment (e�g� through
a light flashing)� If the mains impedance Zmax < 0�335 Ohm, no such
disruptions are expected to occur�
• The high-pressure washer must not be used by children or untrained persons�
• To guarantee safety, only original component parts from or approved by the
manufacturer must be used�
WARNING!
• Risk of accidents�
– Incorrect connection of the equipment’s earth wire can lead to a risk of
Summary of Contents for 220-137
Page 53: ......
