Hamron 011523, Operating Instructions Manual

Page: 18 / 19

EN
18
The roof bracket should be mounted
with its open side down.
4. Repeat steps 1 to 4 for the other roof
bracket (pos. B).
5. Before fitting the line wheel holders follow
the instructions for inserting the line
through the line wheel holder and the
line wheel for the hook hanger.
6. Fit the line wheel holders (pos. A and D)
in the roof bracket (pos. B) with four roof
bracket screws (pos. G).
FIG. 4
INSTALLATION ON ROOF STUD
AND SMOOTH CEILING
1. Insert one end (pos. E) of the line through
the opening in the line wheel holder without
catch (pos. A) and tie a double knot. The
second knot should be placed over the first
knot. The double knot should be big enough
to prevent it going through the hole.
2. Insert the other end of the line through
the hook hanger (pos. C) line wheel.
Now insert the line through the line
wheel holder without catch (pos. A).
FIG. 5
3. Insert the free end (pos. E) of the line
through the line wheel holder with catch
(pos. D) under the catch and through one
of the holes (fig. 5).
4. Pull through the full length of line. Insert
the free end of the line back through the
line wheel holder with catch (pos. D).
5. Insert the line end through the still
unused second hole and back under the
catch. Pull through an extra length of line
and insert the end of the line over the
second line wheel.
FIG. 6
6. Finally insert the free end of the line (pos.
E) through the second line hook hanger
• If there are roof studs concealed behind
plasterboard or anything else, use a stud
detector to locate them.
• Check that the installation point provides
ample distance to walls and other
obstructions.
• The roof studs and the surrounding roof
must support the weight of the product
and the maximum product load.
• The roof brackets (pos. B) must be
mounted in the middle of a heavy-duty
and stable roof stud. To determine the
correct distance between the two roof
brackets (pos. B), measure the length of
the object to be hung up and divide by 3.
The gap between the roof brackets should
be no more than 1.5 m. See example in
figure.
FIG. 2
INSTALLATION ON ROOF STUD
1. Hold a line wheel holder (pos. A or D)
against the stud and mark the holes.
2. Drill two holes with a diameter of 9.5 mm
where the holes are marked.
3. Hold one line wheel holder (pos. A or D)
in place on the stud, insert the retaining
screws (pos. I) through the holes, fit the
nuts and screw tight.
4. Repeat steps 1 to 3 for the other line
wheel holder.
FIG. 3
INSTALLATION ON SMOOTH
CEILING
1. Place a roof bracket (pos. B) on the
centre line of the roof stud and mark the
positions of the two mounting holes.
2. Drill two holes with a diameter of 4.8 mm
where the holes are marked.
3. Fit the roof bracket (pos. B) in the roof
with two roof bracket screws (pos. G).