Installation
5
□
Installing the crossbar assembly
AA
BB
2
Secure the crossbar assembly (AA) to the outlet box (not
included) with the outlet box screws (BB). Tighten until snug.
NOTE:
The preassembled mounting screws on
the crossbar should protrude outward.
HAMPTONBAY.COM
Please contact 1-855-HD-HAMPTON for further assistance.
NOTE:
Prior to installation, close or cover the sink
drain and/or any vents near the installation site to
prevent loss of mounting hardware if dropped.
AA
NOTE:
The backplate on the fixture body (A) should be snug against the wall and
the mounting balls (1).
3
Test fitting backplate on the fixture body to the crossbar assembly
□
□
□
Unscrew the two mounting balls (1) from the crossbar assembly (AA).
Fit the backplate on the fixture body (A) to the crossbar assembly (AA) and secure with the mounting balls (1).
*If this does not work, adjust the length of the mounting screws on the crossbar assembly (AA) by unscrewing the preassembled
hex nuts.
*Then, screw the mounting screws in or out of the crossbar assembly (AA) until the desired length is achieved.
Once the backplate on the fixture body (A) is secure, remove the mounting balls (1) and fixture body (A) and proceed to Step 4.
Adjust the ring
1
□
Rotate the ring to the top of the fixture.
A
1
