7
Assembly
1
Preparing the canopy
3
Assembling the fan
Preparing the motor
2
Remove the canopy bottom cover (C) from the canopy (B) by
turning the canopy bottom cover (C) counterclockwise.
Remove the mounting bracket (A) from the canopy (B) by
loosening canopy mounting screws (EE) a half turn from the
screw head. Next, turn the canopy (B) counterclockwise to
remove the mounting bracket (A) from the canopy (B).
EE
A
B
EE
HAMPTONBAY.COM
Please contact 1-855-HD-HAMPTON for further assistance.
C
F
FF
GG
HH
HH
WARNING:
Failure to properly install the cotter pin (FF)
could result in the fan loosening and possibly falling.
Remove the cotter pin (FF) and clevis pin (GG), and loosen
the two collar setscrews (HH) from the fan motor assembly
(F) collar.
NOTE:
If a longer downrod is needed (not included), take out
the screw located in the hanger ball, lower the hanger ball and
remove the pin. Remove all three pieces from the downrod, and
assemble them onto the new longer downrod before proceeding
to the downrod installation. Be sure to snap together the 3-pin
connectors, the male plug (II) from the fan and female plug
from the extension cord (DD).
Route the wires through the coupling cover (E), the canopy
bottom cover (C) and the canopy (B) and then through the
hanger ball/downrod assembly (D).
Align the holes at the bottom of the hanger ball/downrod
assembly (D) with the holes in the collar on top of the fan
motor assembly (F).
Carefully insert the clevis pin (GG) through the holes in the
collar and the hanger ball/downrod assembly (D). Be careful
not to jam the clevis pin (GG) against the wiring inside the
hanger ball/downrod assembly (D).
Insert the cotter pin (FF) through the hole near the end of the
clevis pin (GG) until it snaps into the locked position.
Firmly tighten the two collar setscrews (HH) on top of the
fan motor assembly (F).
C
F
E
B
HH
HH
GG
FF
B
D
DD
II
