3
second person to help support the weight of the fixture from below while the wiring connections are
being made). Feed the wire and ground wire through the hole in the center of the mounting strap and
rotate the threaded nipple, canopy loop and preassembled fixture clockwise until the threaded nipple is
secure in the mounting strap. Make sure the fixture cable and ground wires are not twisted during this
process.
8. Wrap the ground wire under and around the ground screw which is marked “GND”, and fasten the
ground screw to make sure the ground wire is securely connected.
9.
Make the ELECTRICAL CONNECTIONS (Required Supply Circuit: 120V, 60Hz):
a.
Connect the negative (raised ribs without writing) wire from the fixture to the negative wire from
the Outlet Box.
b.
Connect the positive (smooth with writing) wire from the fixture to the positive wire from the
Outlet Box.
c.
Connect the ground (bare) wire from the fixture to the ground wire from the Outlet Box.
d.
Secure the connections using the wire connectors. Wrap the wire connections with electrical
tape to secure the connections.
e.
Position the wires back inside the outlet box.
Note:
If you have electrical questions, consult your local electrical code for approved grounding methods
or obtain the services of a qualified, licensed electrician.
10. Slide the canopy back over the canopy loop and tighten to ceiling using the loop ring (Adjust the
length of the threaded nipple if necessary).
11. Check to make sure the canopy is held firmly against the ceiling.
12. Installation is complete. Turn on the power at the circuit breaker or fuse box.
ASSEMBLY DIAGRAM:
1. Outlet Box
2. Wire connector
3. Ground (Bare) Wire
4. Mounting strap
5. Ground screw
6. Negative wire
7. Positive wire
8. Washer
9. Hex nut
10. Threaded nipple
11. Outlet Box Screw
12. Canopy
13. Canopy loop
14. Ring
15. Chain
16. Fixture loop
17. Straight tube
18. Coupler
19. Bent tube
20. Base box
21. Base cover
22. S
pherical nut
23. Socket
24. Candle tube
25. Bulb
26. Fabric shade
