Hammond SK1, Owner'S Manual, Page: 83 / 158

83
Setting the Parameters
VIB&CHO ( Vibrato & Chorus)
In this mode, the settings specifi c to Vibrato and Chorus are adjusted.
To locate this mode:
❶
RATE
Sets the Speed of the Vibrato and Chorus eff ect.
Th
e setting range is 6.10 - 7.25 Hz.
❷ VIBRATO - TREMOLO
Sets Tremolo (amplitude modulation) of the Vibrato and Chorus eff ect.
Th
e setting range is 0 - 15.
❸ EMPHASIS
Sets Emphasis (high frequency boost) of the Chorus eff ect (C1 / C2 / C3).
Th
e setting range is 0 - 9 dB.
❹
MIX
Sets Mix balance of the Chorus eff ect (C1 / C2 / C3).
Th
e setting range is D64 (only the Direct tone, no vibrato tone) - EVEN - 63V (only the
Vibrato tone, no direct tone).
❺ PEDAL
Sets Vibrato and Chorus aff ects on the Pedal part by [LOWER] button.
Th
e setting range is ON/OFF.
❻
DEPTH V1
❼ DEPTH V2
❽ DEPTH V3
❾
DEPTH C1
❿
DEPTH C2
⓫ DEPTH C3
Sets the Depth of each Vibrato and Chorus eff ect mode.
Th
e setting range is 0 - 15.
NOTE: The parameters in these modes are Preset Parameters and are recorded to each Preset.
or, keep pressing either of the [V1/C1], [V1/C2], [CHORUS], [ON UPPER],
[ON LOWER] buttons for a few seconds.
See “Function mode” (P. 68) for operation details.
MENU/
EXIT
ENTER
NOTE: All the parameters in these modes
are Patch Parameters. They are re-
corded into the Patch.
CHORUS EFFECT
The Hammond Chorus/Vibrato is not an eve-
ryday DSP eff ect. It is a re-creation of the vin-
tage mechanical scanner that was included
on-board the classic B-3, through executed in
the digital realm.
PEDAL
On the vintage B-3/C-3, the Vibrato and Cho-
rus aff ects not only Lower part but also Pedal
part via [LOWER] (exactly, “GREAT”) tablet by
the circuit structure. It is divided on later mod-
els.
This parameter simulates that.
❶ ❷ ❸ ❹ ❺
❻ ❼ ❽ ❾ ❿ ⓫