Hammond SK1, Owner'S Manual, Page: 49 / 158

49
Setting Up
UPPER PEDAL LOWER
All LEDs are “Off”
Upper Registration
Lower Registration
Pedal Registration
Disable
Dis
able
Disa
ble
Dis
able
Dis
ab
le
Physical Drawbars
MATCH THE REGISTRATION TO DRAWBARS
When you recall a patch, the Drawbar registration of the re-
corded patch is heard, instead of the physical Drawbar setting.
If you move any Drawbar, its position takes precedence over
the recorded registration, although the recorded preset is not
altered.
If you wish to switch to the physical Drawbar setting, Press
DRAWBAR SELECT
UPPER PEDAL LOWER
On
Upper Registration
Lower Registration
Pedal Registration
E
n
a
ble
Disa
ble
Disable
Physical Drawbars
ASSIGN DRAWBARS TO PARTS
Th is keyboard has 3 parts; UPPER, LOWER and PEDAL. On
the SK1, the keyboard is usually assigned to the UPPER, and,
when you want to sound the LOWER, PEDAL, use the Split
/ Manual Bass Function or connect a MIDI keyboard and/or
Pedalboard and assign each part.
Although there are three parts here, there is only one set of
Drawbars. Th
e [UPPER], [LOWER], and [PEDAL] buttons
allow you to register all the parts.
Th
e Drawbars select buttons are [UPPER], [PEDAL] and
[LOWER]. Which button you choose, sends the registration
commands to proper part of the sound engine.
If you de-select any of the drawbar buttons, the instant control
of the drawbars for that part is suspended. You can “pre-set” a
registration, however (covered in next section)
and hold the corresponding button ([UPPER], [PEDAL] or
[LOWER]) in the Drawbar select until the light blinks then
release it. Th
e physical registration now becomes “current”.
UPPER PEDAL LOWER UPPER PEDAL LOWER
Blink “On”
Upper Registration Upper Registration
Physical Drawbars
not equal
Physical Drawbars
equal
Press
Press again
Press and hold