Page 28
a. Remove four screws which secure metal cover on control
panel assembly.
b. Replace bulb with No. 12 GE 6.3V .15A miniature 2-pin.
c. To replace power switch, unsolder two black leads from
generator power panel.
d. Compress springs on sides of switch and push through front
of control panel.
3–15 PERCUSSION CIRCUITRY, L–100A
With the exception of power supply and terminal strip assembly,
, the percussion circuitry is mounted on the lower left
end block. If access to end block circuitry is required, remove
control knobs before removing end block from organ.
3–16 SIX-VOICE PERCUSSION CIRCUITRY, L–100–1
The power supply, 127–000007 and pedal control board assembly,
063–042051, are mounted on the left (rear view) wall of the
console.
The rhythm voice board, 124–000114, is located on the bottom left
(rear view) of the console.
Summary of Contents for L-100 Series
