12
Noodle 3mm Cross
Plate Assembly
1. Remove the Ring Nut, 3mm Noodle Cross Plate, Knife
and Auger from the Grinder Head before installing the
Grinder Head to the Main Body.
2. Align the notches on the Grinder Head with the tabs on
the Main body.
3. Insert the Grinder Head into the Main Body and push
the lever up to lock into position. The lever will be at the
lock graphic when locked (
FIGURE B
).
4. Insert the Auger into the Grinder Head, Auger Driver
end first (
FIGURE C
).
5. Place the Grinder Knife onto the square portion of
the Auger Pin. The cutting edges (flat side) of the Knife
should be facing out (
FIGURE D
).
6. Place the 3mm Noodle Cross Plate onto the Auger
Pin. Ensure the pin of the Grinder Plate fits into the notch
position of the Grinder Head (
FIGURE C
).
7. Turn the Ring Nut clockwise onto the threaded end of
the Grinder Head until it touches the Cross Plate and is
snug. DO NOT over-tighten the Ring Nut.
8. Place the Tray on the upright part of the Grinder Head.
NEVER use the Grinder without the Tray installed!
FIGURE B
FIGURE C
FIGURE D
Auger
Pin
Cutting edges of the Knife facing out.
ENTANGLEMENT HAZARD: Disconnect power before
cleaning, disassembling or assembling.
!
WARNING
