Chapter 5. Operating the System
EQ-99X Operation & Maintenance Manual
33
of
45
Chapter 5. Operating the System
5.1 Starting the System
Caution
: Once the EQ-99X system
is properly set up, verify that all personnel that will be in contact with the system
are aware of the potential hazards involved as described in
Chapter 1. Safety and Warranty Information
. It is the
responsibility of the user to verify that the
EQ-99X system is safely being used.
This section assumes you are using of the EQ-99-RC Remote Control to provide local control. If using an alternative
control system, substitute the appropriate digital input and output lines from the table
for
the switches and LEDs described below.
1.
Review the status LEDs on the power supply controller. The POWER ON LED should be lit, and neither the
CONTROLLER FAULT nor LAMP MODULE FAULT LEDs should be lit.
Power Supply Controller "POWER ON" LED Illuminated
Figure 23.
2.
On the EQ-99-RC Remote Control, turn the OPERATE switch ON by placing the switch in the "up" position. The
LASER ON LED light illuminates, and laser light is now present in the lamp head.
