Hama 00089321, Quick Start Manual

Page: 7 / 28

10
11
Place the connecting piece (Figure 2) on the back side of the base unit (Figure 3).
The holding mechanism for the connecting piece is located on the back side of the
base unit. Position the connecting piece by pressing slightly and push upward until
the locking lug audibly clicks into the provided opening.
Caution: The arrow on the connecting piece must point in the direction of the antenna
coupler!
Now you can take the base unit, with the attached connecting piece, and easily insert
it into the baseplate mounted in the car.
In order to remove the base unit from the baseplate again (e.g. to change the aerial
coupler), press the base unit with the connecting piece upward.
7. Connecting the HTM-7
7.1 Fasten mobile phone to base unit
Press the release button on the right side of the base unit (Figure 4). The
spring-loaded left clamping jaw now opens. Place your mobile phone in the base unit
so that the mobile phone aerial (see your mobile phone manual) rests optimally on
the aerial coupler. Press the clamping jaws together tightly enough for them to fi rmly
embrace your mobile phone.
It may be necessary to fi rst connect the charging cable for the mobile phone,
depending on the accessibility of your mobile phone’s jack (see charging cable for the
mobile phone).
Note: You can also operate the device without the charging cable. The charging cable
is used only to recharge the mobile phone battery.
To remove your mobile phone from the base unit, grasp the mobile phone fi rmly and
press the release button. Always unhook the charging cable from the mobile phone
before hand.
Note: The clamping jaws mechanism has been lubricated. At extremely low winter
temperatures, the lubricant hardens. This might cause the mechanism to become
more diffi cult to operate.
In this case, do not use force but instead wait a few minutes before operating.
7.4 Connect the 12 V cable
The car cigarette 12 V lighter socket supplies the HTM-7 with power.
Remove the cigarette lighter from the socket and stow it in a
suitable place. Insert the 12 V cable plug into the cigarette lighter
socket. Then insert the small jack plug in the left jack socket on the
lower side of the base unit (+12 V DC). The green LED on the
HTM-7 now lights up.
If your vehicle’s cigarette lighter is powered over the ignition,
you must start the ignition prior to operation.
If you will not be using your vehicle for a prolonged period of time,
then unplug the HTM-7’s 12 V cable. Even though power consumption
is extremely low, car batteries that are already low may be drained.
7.5 Connect mobile phone charging cable
Insert the RJ45 jack plug (modular plug) in the right jack socket
(modular socket) on the lower side of the base unit (charge).
The plug must audibly click into position.
Now place the appropriate adapter for your mobile phone
(included in the delivery package) in the small jack plug on the
other end of the charging cable (some Nokia models do not require
an adapter). Then connect the charging cable to your mobile phone
(as described in your mobile phone manual). If necessary, you must
obtain an appropriate adapter for your mobile phone from a specialised retailer.
Aerial coupler
(exchangeable)
Clamping jaws
Release button
Fig. 4
Position the
connecting piece
here, slightly press
against it and push
upwards towards the
aerial coupler (see
arrow in fi g. 2) until
you hear the locking
lug lock into place.
Locking
lug
Opening for
locking lug
Fig. 2 Fig. 3
Fig. 5
Fig. 6
All manuals and user guides at all-guides.com