Ham radio HF2013DX-A, Instruction Manual

Page: 16 / 37

HF2013DX-A HF AMPLIFER
OPERATION
TUNE Anode capacitor for tuning,
frequencies to 100
LOAD Output capacitor tunes antenna load resistance to amplifier.
100 and high at 0
OFF Power down the am
ON Power up the amplifier.
a delay before the am
remain lit until the unit is ready for operation. Once ready
WAIT
OPR Enables amplifier ready f
note that the WAIT indicator will need to display
amplifier.
STBY Places Amplifier into Standby Mode. The LCD panel will display
If the amplifier is
antenna. Maximum
FPW LCD Bar graph – shows
RFP LCDBar graph –
exceeds 350W the
HV Measures the Anode Voltage.
IA Measures the current of the anode
A HF AMPLIFER INSTRUCTION MANUAL
Page 16 of 37
Anode capacitor for tuning, tuning of Higher frequencies to 0, Lower
frequencies to 100.
Output capacitor tunes antenna load resistance to amplifier. Capacity is low at
100 and high at 0 on the scale.
Power down the amplifier.
amplifier.Heating of tube takes 150 seconds, therefore there will be
a delay before the amplifier is ready for operation. The WAIT
the unit is ready for operation. Once ready this indicator will display
amplifier ready for operation The LCD panel will display
note that the WAIT indicator will need to display WAIT before you can operate the
Places Amplifier into Standby Mode. The LCD panel will display
is in STBY your transceiver will be directly
antenna. Maximum power throughput must not exceed 200 Watts!
shows PEP output power.
shows reflected power of the antenna. If the reflected power
the amplifier switches to STANDBY-mode.
easures the Anode Voltage.
easures the current of the anode in mA.
igher frequencies to 0, Lower
Capacity is low at
0 seconds, therefore there will be
WAIT indicator will
indicator will display
The LCD panel will display OPR – Please
before you can operate the
Places Amplifier into Standby Mode. The LCD panel will display STBY
directly connected to the
00 Watts!
If the reflected power