HF2013DX-A HF AMPLIFER INSTRUCTION MANUAL
Page 14 of 37
CI-V
Mono 3.5mm Jack for connection of ICOMTRXs.For successful
operation selection of ICOM radio and correct baud rate is important
(9600 default)
TCVR
DB-9 -serial port RS232 for YAESU and ELECRAFT TRXs. Correct baud
rate and TRX type is a must for successful operation. If both CI-V and
TCVR cables are used then CI-V wins over RS232. Otherwise selection
of interface is done via TRX type.
PC
DB9 RS232 port is used for communication of your TRX with PC. Use
setting that you would normally use as if using direct connected. Ie.
TRX – PC connection.
ALC
RCA-Phono – Automatic Level Control is used when tuning the PA to
block drive level. WARNING!!! We recommend touse this feature mainly
while operating RTTY, FM and other 100% duty modes.
CONT ROL
DB15 connector for use of single cable between PA and TRX
PIN OUT:
1. ALC Out
2. NC
3. INHIBIT Control voltage
4. TX INHIBITfor Yaesu and Elecraft – this supersedesALC output
5. NC
6. KEY OUT
7. NC
8. KEY IN
9. –
15. GND
Summary of Contents for HF2013DX-A
