Instruction Manual PSx3xxEC
7
Solid shaft:
The PSx3xx is installed on the machine by mounting the drive to the axis to be driven
using a coupling and an intermediate flange.
Under no circumstances may the housing cover be used for the
purpose of the transmission of force.
Underwater usage of the PSW is not allowed
Please consider that the device might have
a hot surface during operation!
2.3
Disassembly
To remove the PSx3xx from the shaft, release the clamp (for versions with hollow
shaft the clamping ring) and pull the PSx3xx off the shaft. If possible, the PSx3xx
should only be pulled axially. Excessive bending back and forth can damage the
output shaft!
For versions with brake, it is essential to observe the instructions in sections 4.9 and
4.10!
2.4
Powering the device
For motor power use a single fuse with max. 3,5 A for each PSx3xx.
For motor power use a single fuse with max. 10 A for each PSE34xx.
For control power you can use a fuse with max. 2,0 A, so it is
possible to power up to 10 units parallel with one fuse.
It is strongly recommended to separate power cables to the PSx3xx
from other power cables that might have dangerous voltage.
