97884C (Rev. A - 3/06)
PAGE 9
RC8AQ*A RC12AQ*A
INSTALLATION INSTRUCTIONS
FOR THE
RC MODEL DRINKING FOUNTAIN
(Cup Dispenser With Glass Filler)
1.
The 14700
Model Cup Dispenser with Glassfiller is designed to complement model RC drinking fountains. The
fountain should already be installed before beginning installation. If not refer to page 2 for your model. Remove
louvered access panel from fountain via the two screws at the bottom.
2.
Check
wall opening to see if provisions have been made to accept this cup dispenser. If they have not, refer to
page 2 for rough-in instructions. CAUTION: Wall construction must be framed to support fountain and cup dis-
penser (approximately 150 pounds).
3.
See
Parts List Illustration (page 10) for cup dispenser tailpiece. Decide which style of waste trap you intend to use.
For easier installation, we recommend the use of a swivel trap.
4.
Orientate
yourself to the configuration of the cup dispenser. Open front door and remove the spring loaded trash
access panel. To remove access panel, just loosen the four mounting screws and pull out the panel. Also remove
the waste bin. Note location of mounting slots in the wall box portion of the cup dispenser. The slots are for affixing
wallbox to building construction.
5.
Put
cup dispenser in wall opening. Determine shimming required to obtain a good alignment with fountain. Open
and close door to ensure proper operation. CAUTION: Do not “suspend” cup dispenser via the mounting slots - be
sure to shim along bottom edge to bear the weight of the cup dispenser.
6.
Secure
cup dispenser in place. Use lag screws or bolts as required by wall construction.
7.
Install
glass filler supply tube assembly. (See Figure 13). Put glass filler fitting through hole provided in back, put
gasket on from the front and screw on the hexagonal mounting nut.
8.
Install
glass filler. First remove the blue handle, then screw the glass filler into the glass filler fitting. Reattach blue
handle.
9.
Make connections between remote chiller outlet tube and fountain.
Outlet port is marked on the
chiller (1/4” O.D. copper tube). Install a 1/4” x 1/4” tee (provided) on the marked chiller outlet port. Insert the 1/4”
poly tubing coming from the fountain into the tee. Connect glass filler line to outlet on tee. Install a 1/4” x 3/8” union
(provided) on the glass filler outlet line. Insert a piece of 1/4” poly tubing from the tee to the union. Turn on the
water supply and check for leaks.
DO NOT SOLDER TUBES INSERTED INTO THE UNION/TEE AS DAMAGE TO THE
O-RINGS MAY RESULT.
(See Fig. 9)
10.
Install
tailpiece assembly (as shown in Figure 14). Connect waste trap (not provided).
11.
Turn
on supply water and operate push button valve and glass filler. Check entire system for leaks. Water flow
from the glass filler can be adjusted by turning the flow adjusting screw (See Figure 13). In order to adjust, it may
be necessary to remove, and then reinstall the glass filler, per step 8 above.
12.
Replace
the spring loaded trash access panel via the four mounting screws. Reinstall louvered grill on the
fountain.
