PAGE 2
RC8AQ*A RC12AQ*A
97884C (Rev. A - 3/06)
FIG. 3
FIG. 4
1.
Cut
a wall opening 24 7/8 W x 48 1/2 H (with cup dispenser), 17 1/8 W x 48 1/2 H (without cup dispenser). The bottom
edge of the opening should be approx. 16 1/8” above the floor (See Fig. 3 with cup dispenser). See Fig. 4 without cup
dispenser. Check local codes for height requirement.
2.
After
opening is completed, reinforce opening on all sides so that it may adequately support water cooler which
weighs up to 150 lbs. and also provides a means of securing Wall Frame in place. (Install a wall stud indicated on
Fig. 3 (with cup dispenser). NOTE: Building construction must allow for adequate airflow on both sides and top of
chiller unit. 4” minimum required.
3.
Install
rough plumbing to fountain. See Fig. 5 for location of supply water inlet to chiller and location of waste water
outlet.
*For cup dispenser model without glass filler plumbing, continue with step no. 5.
4.
(Cup dispenser Models)
Install rough plumbing to cup dispenser. See Fig. 15 for location of waste water outlet.
5.
Cut
plastic ties holding chiller shelf support rods to framework.
6.
Install
wall frame assembly in wall opening with front edge of frame flush with finished wall face. Secure frame
through holes in top and sides to wall support members with 5/16” diameter fasteners (bolts or lag screws) as
required by wall constructions. (14) bolts/screws required. CAUTION: DO NOT USE LESS THAN REQUIRED
QUANTITY AND SIZE (DIAMETER) OF FASTENERS.
7.
Install
chiller shelf. Place shelf on lower frame member and attach support rods. Secure front edge of the frame and
wall construction using two 5/16” diameter lag screws or bolts. Tighten securely.
8.
Install
electrical conduit. Fig. 5 shows electrical conduit connection location.
9.
Now
you are ready to install fountains.
WALL FRAME INSTALLATION INSTRUCTIONS
FOR THE
RC MODELS DRINKING FOUNTAIN
(with and without cup dispenser)
