Getting Started with the HaloFogger®
I
MPORTANT
Before using your HaloFogger, it is important that you:
1. Plug the HaloFogger into a power source for 24 hours to fully charge the HaloLog’™
Data Logger’s internal back-up battery.
2. Download the HaloMist™ All-Purpose Disinfectant Use Instructions.
Go to
www.halosil.com
, register your new fogger purchase to download.
Setup and Filling
THE HALOFOGGER IS DESIGNED FOR USE WITH HALOMIST™ ALL-PURPOSE DISINFECTANT AND SHOULD NOT
BE OPERATED WITH ANY OTHER MANUFACTURERS DISINFECTING OR CLEANING PRODUCT.
Setup Instructions
Locate the connector end of the power cord. Insert the connector into the power receptacle located at
the bottom of the rear panel of the HaloFogger. Ensure that the connector is securely in place. Plug the
HaloFogger into a standard electrical outlet. The green status indicator light will illuminate.
Filling Instructions
1. Open the HaloFogger Reservoir Door by lifting front edge of door.
2. Locate the disinfectant fluid level indicator lights to the left of the funnel. One flashing red light will be
illuminated indicating the HaloFogger is empty.
3. Use personal protection equipment (PPE) including wrap-around style goggles and gloves when pouring
disinfectant fluid into the device.
4. Open a gallon (3.8 liters) bottle of HaloMist™ Disinfectant and SLOWLY pour the contents into the funnel
area. AVOID SPLASHING.
5. The fluid level indicator lights will illuminate as you pour to show how much disinfectant is in the device.
6. The HaloFogger holds two gallons (7.6 liters) of disinfectant when full. Stop pouring when the top green
light on the fluid level indicator is illuminated. Do not overfill.
7. Wipe up any spills with a clean paper towel or rag. Thoroughly rinse off gloves and hands.
8. Close Reservoir Door.
9. The HaloFogger is now ready to be used.
Basic Operating Instructions
1. Set the timer to the number of minutes specified for your room size. See Quick Instructions on rear
of unit.
2. Plug the HaloFogger into a standard, grounded electrical wall outlet. When the power connection has
been made, the green status indicator light on top of the device will illuminate.
3. Check fluid level indicator lights. It is recommended the unit’s reservoir be topped off before starting the
treatment process. Refer to “Getting Started with the HaloFogger” above to add/refill disinfectant.
4. Press and hold the Start button for two (2) seconds. The green status light will begin to flash red indicating
you have thirty (30) seconds to leave the room before the unit begins to dispense disinfectant.
5. Leave room, close and seal door. Post sign on door indicating the room should not be entered during the
treatment process.
HaloFogger® Operation Manual_1911