9
Safety Information
• Only start the machine when the
hood is closed and locked and the
lever of the shaking device has been
pushed in.
• Before starting work, the operator
must be fully familiar with all
adjustment, operating and control
elements as well as their respective
function! It is too late to do this when
the machine is actually in operation!
• Always wear heavy duty, non-slip
footwear when working with the
machine.
• The machine may only be used on
those surfaces which have been
approved by the contractor or person
appointed by him.
• The manner of driving must be
adapted to the local conditions.
• It is forbidden to use the machine in
potentially explosive atmospheres.
• Do not let the engine run indoors!
Risk of poisoning (only
Sweepmaster P650)! Ensure
sufficient ventilation when working
indoors.
• When using the machine, it is
essential to pay attention to third
parties, especially children.
• Pay attention to hot parts of the
engine, risk of burns.
• It is prohibited to transport
passengers.
• Accelerate the machine immediately
after switching on the rotary brush,
otherwise imprints of the brush could
be produced on the floor.
• Never leave the machine unattended
as long as the engine is running.
• Remove the ignition key to prevent
unauthorized use of the machine.
• Never leave batteries in a
discharged state but recharge them
as soon as possible (only
Sweepmaster B650).
• When transporting the machine,
switch the engine off and raise the
side brush.
• The Sweepmaster can be used on
surfaces with a maximum gradient of
2%.
• Steps or curbs up to a maximum of
4 cm can be driven over.
• It is forbidden to manipulate switches
and safety equipment.
1.4
Maintenance information
• The maintenance work and
maintenance intervals prescribed in
the instruction manual must be
adhered to.
• Operating personnel must complete
the necessary daily and weekly
maintenance work. All other
maintenance work must be
completed at your nearest Hako
service center.
• The machine must be inspected by a
recognized technical expert in
respect of operational safety, within
the terms of the applicable accident
prevention laws, at reasonable
intervals (we recommend at least
once a year) and following
modification or repairs.
• Spare parts must comply with the
minimum technical requirements
stipulated by the manufacturer! This
is ensured by the use of original
spare parts.
• The machine must be switched off
prior to cleaning or servicing it or to
replacing parts.
