OPERATION
Press the button once.
Press the button once.
Press the or button.
UP
DOWN
3. Enter the TENS digit
• Press the
or
button to select the
desired value for the TENS digit. Any
value from 0 to 9 can be selected. When
the desired value is displayed, press the
button. The UNITS digit begins to
flash.
4. Enter the UNITS digit
• Use the
or
button to select the
desired value for the UNITS digit. Any
value from 0 to 9 can be selected. When
the desired value is displayed, press the
button. This will store the temperature
setting in memory and display the tem-
perature setting. Heater control begins.
Remove the card to lock the data.
NOTE:
If the power switch is turned off, or power is lost
during the execution of this procedure, no data will
be entered. The entire procedure must be repeated
from step 1.
When the station is ON ( ) and
the card is in the station, the data
entry procedure follows:
1. Hold the
button down for at least one
second.
2. The current temperature setting will be
displayed, then the HUNDREDS digit will begin
to flash. This indicates that the station has
entered the temperature setting mode.
3. Continue with the procedure of 2-4 above.
7
