HAKKI PILKE RAVEN
TRANSLATION
VERSION 1-2015
4.8 CHANGING THE OIL OF THE MULTIPLIER GEAR
1.
Run the machine for a while in order
to warm up and mix the oils.
2.
Turn off the tractor and remove the
cardan shaft from the multiplier gear
splined shaft.
3.
Open breather cap A in Figure 30 (this
will allow the oil to drain more easily)
as well as drain cap B, and drain the oil
into a suitable container.
4.
Close drain cap B.
5.
Add
0.09 litres
of appropriate oil to
the angle transmission through the
breather opening. (The multiplier gear
is small, so approx. 1 dl of oil is suffi-
cient).
6.
Finally, close breather cap A (Figure
30).
Figure 30.
4.9 CONVEYOR MAINTENANCE
Replacing and tightening the input conveyor belt
Replace the input conveyor belt as fol-
lows:
1.
Turn off the machine and disconnect it
from its power sources.
2.
Raise and lock the input conveyor into
the transport position. (See Section
2.3).
3.
Move the belt joint to a suitable
height.
4.
Disconnect the joint by using pliers, for
example, to pull out pin A (Figure 31)
that holds the joint together.
Figure 31.
