HYDROK
Commissioning
80
Order h49 7144.907-333
8 Commissioning
For commissioning purposes, set the operating pressure to
the permitted, established machining value.
The machine tool must not start up until full operating pres-
sure has built up.
8.1 Commissioning safety
DANGER
Serious injuries caused by workpieces being
ejected centrifugally or dropping out if clamping
force is insufficient!
Workpiece blanks must not be outside the clamp-
ing width diameter.
Prior to commissioning, set the actuation force to
the permitted, established machining value.
Clamping of the workpiece must not be outside
the defined limits [see »Limits of use« chapter].
Check the clamping force at regular intervals and
correct if necessary.
WARNING
Serious injuries can be caused if the machine tool
starts up accidentally!
Prior to commissioning, close all safety doors or
hoods on the machine tool.
WARNING
Serious injuries caused by tools and items of test
equipment being ejected centrifugally!
Prior to commissioning, ensure that all tools and
items of test equipment are removed from the
working area of the machine.
NOTE
Serious damage to materials / the product caused
by workpieces being ejected centrifugally or drop-
ping out if clamping force is insufficient!
Workpiece blanks must not be outside the clamp-
ing width diameter.
Prior to commissioning, set the actuation force to
the permitted, established machining value.
Clamping of the workpiece must not be outside
the defined limits [see »Limits of use« chapter].
Check the clamping force at regular intervals and
correct if necessary.
