HYDROK
Technical data
24
Order h49 7144.907-333
The achievable clamping forces resulting from actuating
forces must be checked at regular intervals. For this, struc-
tural clamping force measurements must be performed.
The clamping force measured must be in the approved range
[see »Clamping force diagram« chapter].
3.3 Balancing quality
The product is balanced before leaving the factory [balanc-
ing quality - see »General information« chapter].
DANGER
Serious injuries caused by parts being ejected
centrifugally if products are not balanced cor-
rectly!
Do not clamp rotationally symmetrical work-
pieces, or do so only after contacting the manu-
facturer.
Never remove balancing screws and weights at-
tached to the product.
NOTE
Material damage caused by machining with incor-
rectly balanced products!
Do not clamp rotationally symmetrical work-
pieces, or do so only after contacting the manu-
facturer.
Never remove balancing screws and weights at-
tached to the product.
3.4 Speed
The product is authorized for rotational operation.
The maximum speed is written on the product [maximum
speed, see »General information« chapter].
DANGER
Serious injuries caused by projectile parts ejected
when the product is used improperly!
Always pay attention to media feed lines when ro-
tating the product.
When using the side ports, the product must not
ever rotate.
DANGER
Serious injuries caused by parts being ejected
centrifugally due to a non-compliant combination
of several products!
From all of the maximum speeds indicated for the
combined products, always remain at the lowest
of those maximum speeds.
