5
3 Operating Instruction
3.1
Reset the Master Code
Operating steps
Locks status
Use screwdriver to move away back
panel. You will see a button beneath the
battery case, press the button for 10
seconds until the front panel indicator
light flash blue.
When you press the button, you will hear one beep and the
front panel indicator light flash red, After 10 seconds, you
will hear two beeps, and the light change to blue, now the
master code is reset to 123456.
Note: If you just get this lock and haven
’t set any code, then skip this step. This operation will clear all the
users added before.
3.2 Modify Master code,
4-8 digits (eg.:12345678)
（
11#
）
Operating steps
Locks status
1
Press “
#
” to start the lock
You will hear two beeps, front panel indicator light flash
blue, and keypad illuminate.
2 Input the initial master code:
“
123456
”
,then
press
“
#
You will hear two beeps.
3 Input “
11
” then “
#
” within 10 seconds(before
the indicator light extinguishes)
You will hear two beeps.
4 Input
“
New Master Code
”(4-8digits) then “
#
” You will hear two beeps.
5
Input
“
New Master Code
” again, then “
#
”.
You will hear 4 beeps, indicator light extinguishes, New
Master Code set successful.
Note: If there is no react after you press the
“#”, the keypad dose not illuminate, then take out all the
batteries and press the reset button for 5 seconds, and then put the battery back and follow the
instruction again.
3.3.Add Normal User
（
01#
）
3.3.1 Set user group before add normal user, user group consist of 3 digits, from 001 to 200, and each
number can only be used once. For example, if you want to set up 2 code users, 2 card users. You
need 4 groups, such as 001,002,003,004.
3.3.2 You can set up
200 Users in total
, include the Code User, Card User, Code&Card combination User.
3.4
Add Code User
Operating steps
Locks Status
1
Press “
#
” to start the lock
You will hear two beeps, front light flash blue,
and keypad illuminate.
2 Input the “
Master Code
” then “
#
”
You will hear two beeps.
3 Input “
01
” then “
#
” within 10 seconds(before the
indicator light extinguishes)
You will hear two beeps.
4 Input “
user group number
” such as “001”
within
10 seconds(before the indicator light extinguishes)
then “
#
”(Group number can only be used once.
Next time if you want add another user, you need to
use another group, such as
“002”,”003”….”200”)
You will hear two beeps.
