Press the “ Wash ” button to set
washing time.
Display washing program,
washing time, remaining
time,delay time,times of
rinsing, spinning time,
temperature setting value,
child lock state,door lock
state ,program progress and
alarm message,etc.
After setting relevant parameters,
press the “Start/Pause” button
once, the selected program will
automatically start running. If this
button is pressed when the
program is running,the program
will pause;to continue the
program,just press this button
again.
Note: Washing time doesn’t
include water-feed time and
heating time.
Press the “Rinse”button to select
the times of rinsing and the
maximum allowable times of
running is 8.When the display
screen doesn’t display the times of
rinsing, it indicates that the
washer-dryer will not perform
rinsing.
Press the “Spin” button to select
spinning time. The maximum
allowable spinning time waries with
programs.When the display screen
doesn’t display the spinning time, it
indicates that the washer-dryer will
not perform spinning.
The spinning time means the time
for spinning at high speed.
Press the “Dry” button to select the
“Dry” program.
The “Dry” program is only available
in the “Wash & Dry” and “Dry”
modes.
Press the “Temp.” button to
select the heating temperature
(30, 40, 50, 60, 70, 80 or
90).The maximum allowable
heating temaperature varies
with program.
When the display screen
doesn’t display the
temperature, it indicates that
the washer-dryer will not heat
for washing.
6 Control Panel and Program Description
“Wash” time
Display screen
“Delay” selection
“Temp.” selection
“Start/Pause” button
Before starting the selected washing program,press the “Delay” button once and
set the delay time by turnng the program knob. the delay time (0.5-24h) increases
(decreases) with the increment of 30 minutes by clockwise (anticlockwise) turning
the program knob. Press the “Start/Pause” button, the selected program will start
and the delay time will start counting down. After selecting the “Delay” function but
before starting the selected program,press the “Delay” function will be canclled.
The delay time is the end time of washing. For example,6:00 means the washing
ends after 6 hours (if the delay time is shorter than the time required by program
running,the washing program will start running immediately after pressing the
“Start/Pause” to start the “Delay” program).
This function is not available for “Air-wash”,”Drying with rack” and “Self-clean”
program.
9
9 Operational Procedures
14
Place the
drain pipe.
Insert the
power plug
into a power
socket.
O
pen the door,put
the clothers to be
washed in the
washer-dryer,then
close the door.
A
dd
a proper amount of
detergent in the
distributor bo
x
.
Press the
“
Strat
/
Pause
”
button to
start the
selected
program.
Select the desired program by turning the
program knob. Select proper washing time,
times of rinsing,spinning time,spinning speed,
the
“
Dry
”
program and heating temperature as
required.
Press the
“ON”
button to turn
on the washer-dryer.
Select the
desired
mode.
C
onnect the
water inlet pipe
firmly and turn
on the water
tap.
T
imes of
“Rinse”
