15. When washing small articles (e.g. handkerchiefs, gloves, socks, etc.) and those clothes liable to
inter-twist and wear, please put them in net bags for washing, rinsing and spinning to prevent them from
falling into between the inner drum and window pad and further avoid inadequate washing and drying. The
weight of articles in each net bag must not exceed 300g and the net bags should be put in the washer-dryer
together with those clothes not in a net bag, otherwise the washer-dryer will not be balanced and result in
abnormal vibration. Reference weights for small articles: handkerchiefs about 30g/piece; gloves about
60g/pair; cotton socks about
30g/pair; silk socks about 20g/pair.
16. When spinning at high speed, the clothes will stick on the washer-dryer’s inner drum wall due to
centripetal force. If the clothes are to be dried, it is recommended to take them out and fluff them
out, then put them in the washer-dryer again for drying to achieve optimal drying effect.
17. During heating or drying, high temperature inside the washer-dryer may cause temperature rise of the
tabletop panel and door, etc. Therefore, do not touch the tabletop panel and door during heating or drying.
18. During drying, it is recommended not to load the inner drum with clothes over the height of drying sticker
on the electroplated ring; otherwise inadequate drying may occur.
To clean the drying filter box
Note: Please clean the drying filter box after using the drying function every time.
(1) Pull out the drying filter box as shown in Fig. 1.
(2) Gently open the drying filter box cover as shown in Fig. 2.
(3) Remove the flocking in the drying filter box with a soft bristle brush as shown in Fig. 3.
(4) Close the drying filter box and install it in place.
Fig. 1
Fig. 2
Fig. 3
Note: The flocking must not be piled up around the washer-dryer to avoid its entry into the washer-dryer
and poor drying effect.
To clean the water inlet filter screen
Warm tips: To improve the washing effect, do not
throw away the water inlet filter screen. In case of
unsmooth water feed, please clean the water inlet
filter screen in time as follows:
(1) Screw off the water inlet pipe as shown in Fig.1,
and then take out the filter screen with a pair of
nipper pliers as shown in Fig. 2.
(2) Wash the filter screen with a soft bristle brush.
(3) Install the filter screen in place and connect the
water inlet pipe.
Fig. 1
Fig. 2
3
20
