Haier Super Match Series, Service Manual, Page: 200 / 483

Maintenance
Setting of proper room
temperature
Close doors and windows
If the unit is not to be used
for a long time, turn off the
power supply main switch.
Use the timer effectively
Use the louvers effectively
Do not block the air inlet
or outlet
Proper
temperature
During cooling
operation prevent
the penetration of
direct sunlight with
curtain or blind
OFF
Remote Controller
Indoor Body
For Smart Use of The Air Conditioner
Do not usewater, wipe the controller
with a dry cloth.Do not use glass
cleaner or chemical cloth.
wipe the air conditioner by using a
soft and dry cloth.For serious stains,
use a neutral detergent diluted with
water. Wring the water out of the
cloth before wiping,then wipe off
the detergent completely.
Air Filter cleaning
Open the inlet grille by pulling it upward.
Clean the filter.
Attach the filter.
Close the inlet grille.
Push up the filter's center tab slightly until it is
released from the stopper, and remove the filter downward.
Use a vacuum cleaner to remove dust, or wash the filter with
water. After washing, dry the filter completely in the shade.
Attach the filter correctly so that the “FRONT” indication is facing to
the front. Make sure that the filter is completely
fixed behind the stopper. If the right and left
filters are not attached correctly, that may
cause defects.
Do not use the following for cleaning
Once every
two weeks
Clean the filter
Caution
Clean the indoor(outdoor) unit
Clean with warm cloth or neutral detergent, then wipe away moisture
with dry cloth. Do not use too hot water(above 40 C), which will cause
discoloration or deformation. Do not use pesticide or other chemical
detergents.
o
Do not wash filter in hot water above 40
Do carefully wipe the filter.
o
C,which will damage the filter.
Use water or vacuum cleaner to remove dust. If it is too dirt,
clean with detergent or neutral soap water.
Rinsing with fresh water, dry the filter and re-assemble.
during operation
O Gasoline,benzine,thinner or cleanser
may damage the coating of the unit. Hot water over 40 C(104 F) may
cause discoloring or deformation.
O
Remove the filter.
Domestic air conditioner
System configuration
199