3-Control panel
GB
10
Note: Liquid detergent
If using liquid detergent, it is not recommended to activate the end time delay.
3.6.1 Function “Memo”
A programme with all of its settings can be saved for
reuse by pressing this button (Fig. 3-8).
1. Set the programme with all desired functions.
2.
Press the button „Memo“ for 3 seconds. A signal
sounds and the indicator lights up.
When you want to use the stored cycle you just only
press the „Memo“ button. The indicator lights up and
the stored cycle is activated.
Delay
Memo
Speed
up
3-9
Memo
3-8
3.6.2 Function “Speed up”
This function (Fig. 3-9) saves time and energy. Prefer-
able if laundry is slightly soiled.
3.6.3 Function “Delay”
Press this button (Fig. 3-10) to start the programme
with a delay. End time delay could be increased in steps
of 30 minutes from 0,5-24h. For example display off
6
:
30
means end of programme cycle will be in 6 hours
and 30 minutes. Press “Start/Pause” button to activate
the time delay.
The time delay must be longer than the programme run
time. Otherwise the programme will start immediately.
For deactivating the time delay; rotate programme se-
lector.
Delay
3-10
3.6 Function buttons
The function buttons (Fig. 3-7) enables additional op-
tions in the selected programme before programme
start. The related indicators are displayed.
By switching off the appliance or setting a new pro
-
gramme, all options are disabled.
If a button has multiple options, the desired option can
be selected by pressing the button sequentially.
To delete the setting or to cancel the setting process,
press the function button until the desired LED lights
or -in case of only one option- the LED switches off.
Not all functions are available for all programmes (see
PROGRAMMES).
Temp.
Stains
Extra
Delay
Speed
Intense
Memo
speed
rinse
up
Spin
3-7
3-7
Note: Factory settings
To get best results in each programme Haier has well defined specific default settings. If
there is no special requirement default settings are recommended.